@José-Luis-Cánovas that is very informative. Do you have guides that novice like me can follow along how to setup these? Like what you state "You should remove console totally. Remove SSH root login with password, add other accounts with SSH certificates for login."

Anyone got it streaming over internet?

Hello,
Is there a torrent client for Omega2+?

@José-Luis-Cánovas that is very informative. Do you have guides that novice like me can follow along how to setup these? Like what you state "You should remove console totally. Remove SSH root login with password, add other accounts with SSH certificates for login."

@abd Have you tried pagekite.net? it is an open souce pyhton, but not so sure if can run on Omega2. It sure run on raspi...

@luz What PCB did you design? Care to share?

@Ken-Conrad looks good, but I may require USB host...
Waiting for @Daniel-Andrade PCB...

hello I dont think the width of the Omega itself will fit breadboard plus the 2.54mm pitch headers. So it is not possible to be breadboard friendly anyway, except for the breadboard dock (expensive) which makes the board longer.
Now will wait for your PCB...

@Ken-Conrad Thank you for the information. The other PCB doesnt have USH host connector, not suitable for me.
@WereCatf How to order this PCB by the way?

@WereCatf If not for breadboard, so it means it will be on some kind of proto board?
NodeMCU V1 as shown was first not breadboard friendly at first..

The work around they did were like...

Then due to market demands they make V3 smaller to fit the breadboard...

I hope you will consider being breadboard frieldly even using 2pcs of breadboard.

I observed P2 might hit the Omega. You can align, P3 and P5 to the first pins of the Omega and cut the PCB along that line. The antenna of the omega will be protruding, but it will be better so it will be fully exposed. Then P1 and P2 and 6pin will be on the other side.