@alejandro-neujovics I had created one. I've since updated the firmware to 3.2 b218 and my overlay and swap page isn't working any more. Trying to set it up again, but it seems the mounting of the external devices has changed so the instructions don't match any more. I seem have the overlay set up again, but now I can't set up a swap page on the overlay per the instructions for that, so I'm having trouble increasing the memory.

I had an overlay setup with the older firmware that didn't work once I updated the firmware to the latest. I went to re-establish the overlay per the instructions on the onion site, but there is no /tmp/mounts folder any more. It appears as though there is an overlay setup already but would need to changed to the sd card? Are there updated instructions?

Every time I power down the Omega 2+ and power it up again, I have to go through the setup (when I go to the address in a browser, it comes up with set up your omega). This just started. It had been working. I've updated to the latest v3 firmware to see if it was a firmware issue but still have the same problem.

@Jeff-Seese I tried that but I don't have the /tmp/mounts folder after upgrading to 3.2 b218? I seem to get it to work without the first umount. But now I can't set up a swap page on the overlay. Any suggestions?

@alejandro-neujovics I had created one. I've since updated the firmware to 3.2 b218 and my overlay and swap page isn't working any more. Trying to set it up again, but it seems the mounting of the external devices has changed so the instructions don't match any more. I seem have the overlay set up again, but now I can't set up a swap page on the overlay per the instructions for that, so I'm having trouble increasing the memory.

I had an overlay setup with the older firmware that didn't work once I updated the firmware to the latest. I went to re-establish the overlay per the instructions on the onion site, but there is no /tmp/mounts folder any more. It appears as though there is an overlay setup already but would need to changed to the sd card? Are there updated instructions?

Thanks. I will check that out.

Are there plans to update the opkg version of node to be a more recent version. If not, is there a way to install the LEDE version of the node package?

I'm trying to expose a localhost port running on the omega 2+ using Node and localhost.run and ssh -R 80:localhost:1234 ssh.localhost.run. It runs the first time, but then won't run again, then it will run, then it won't and returns an error message about Non-matching signing type. Any suggestions?