When I try to upgrade the firmware on the Dash to 23.05.3, sysupgrade says Device omega2dash not supported by this image. openwrt-imagebuilder-wrapper doesn't seem to support it either.

Is there a way to make this upgrade work? I'm pretty sure it's bricked a device already.

EDIT: The upgrade installed, but has to be used via the serial console at first. (This probably belongs somewhere in the update notes.) Now I have to figure out which packages to install

@crispyoz thanks for letting me know! It looks like the factory tried to glue it down but didn't apply enough to even reach the connector (or it spilled out — there's a stain on the board below the connector.)

I just received my Dash boards from Crowd Supply this morning and the first time I plugged in power the Micro-B connector broke right off! The tabs that should be holding this on the board are far too short and the connector is incredibly fragile — even the slightest upward pressure will break it off.

When you plug in your Dash, hold the connector down firmly with a finger to prevent this.

I’ve filed a support ticket so Omega is aware of the problem (and hopefully will set me up with a replacement.)