I pulled the LED blinking tutorial and followed the instruction but ended up getting the "ImportError: No module named onionGpio" error message. I am not sure why it was missing but I used the following command to install the Python module.

opkg install pyOnionGpio

@crispyoz, I was able to update the firmware to Ω-ware: 0.3.2 b237 and make the device connected to the internet. Thank you very much for your help.

@crispyoz , I was able make the WiFi SSD of the Omage2+ show up somehow after login to the device through serial. I have run wifimanager and enabled the wifi. I am not sure this is what resolved the issue but it was one of few things I have tried.

However, I have a different issue now. I cannot connect the device to my wifi with Omega2 Setup Wizard. It would say "Unable to connect to SSD_name. Please try again" on the web and I see following in the terminal having the devices connected via serial. Is there something I am doing wrong?

[ 602.839731] =====================================================
[ 602.845911] Rule 1 CCA value : Min Dirtiness (Include extension channel) ==> Select Channel 10
[ 602.854741] Min Dirty = 124
[ 602.857573] ExChannel = 0 , 0
[ 602.860603] BW = 20
[ 602.892128] br-wlan: port 2(ra0) entered forwarding state
[ 602.897694] br-wlan: port 2(ra0) entered forwarding state
[ 604.889221] br-wlan: port 2(ra0) entered forwarding state
[ 608.336487] !!! APCLI LINK UP - IF(apcli0) AuthMode(7)=WPA2PSK, WepStatus(6)=AES!

@crispyoz, I have no idea. I purchased the device when it was first released and didn't upgrade the firmware. I cannot access the device via Wifi so I cannot tell you which firmware is on it.

I have Omega2. I had been able to see the WiFi SSD and connect to the device before I attempted to upgrade the firmware. However, the SSD doesn’t show up anymore and I cannot connect to the device. Did anyone have this problem? What should I do?