@crispyoz Thanks for that

On further review of the wifi config file the 'config wifi-device' section sets the hwmode to 11g and channel to auto - could this be causing packet handling issues? Do you know where to find the various options for the config file? Thanks

@crispyoz said in Previous firmware restore:

Onion proprietary closed source driver

Got it. Assuming I can install a new driver using:

opkg install kmod-wireless-<driver-name>

Will the Warp Core driver need to be removed using:

opkg remove kmod-wireless-<driver-name>

or will a simple 'unload' do: modprobe -r <driver-name>

Thanks

@crispyoz Sure (below) - is there anything we can do to stop the scanning?

@crispyoz Thanks for that

We have had an interesting change that we thought we needed the firmware restore for (not needed now):

1. We are setting up the Omega2S+ Pro and switching to AP mode after set-up. Board works fine with minimal latency/jitter issues for months
2. Recently (past 2 weeks), network/latency issues getting really bad (particularly in different physical location to where the board was set-up i.e. the board is not in set-up network range)
3. Changed to AP-STA mode in the new setting and the network issues resolved - in both the new and the old location

Any ideas as to the cause or next steps? Does the system get to a certain time point and want to update even in AP mode? Our understanding was that the board in AP mode will essentially be 'frozen' in the current state but perhaps we are wrong?

Hi - we are running an Omega Pro 2S+ and have experienced some recent performance issues. How do I go about restoring the firmware/openwrt to what it was 4 months ago (for example)?

Thanks, S

Hi,
I am attempting to use the omega2 maker kit.
Set-up - initially the SSID was visible and set-up proceeded with no issues via safari
Upon successful set-up I can no longer see the SSID
Solid yellow light on the board is visible

Any ideas on what can be happening and next steps to resolve?

Thanks

Hi all,

New to the forum and I've looked around for advice with regards to USB cameras. I see multiple issues with power supply etc.

Question: Are there any user recommended/verified USB cameras that work with the set-up that I should start with?

Thanks