Hi Boken,
Thanks for taking time to respond, especially since it's so close to Christmas.
I don't have an ethernet expansion but I'm a long time hobbyist so I have all kinds of resistors, caps, etc., plus various Arduino boards. The two Omega expansion boards I ordered with the unit are the basic USB board and the Arduino Uno pinout compatible expansion board. Is there any chance of using that board with it's Atmel chip to reflash the Omega?
Merry Christmas,
johnfirmware upgrade failed - factory reset failed.
At this point I believe I may have made a (tiny) doorstop out of my omega.
The factory reset instruction did not specify that we would get a message during upgrade install "....[w] unreachable.." on the serial console window. The webpage just says it will take a few minutes. As I thought the upgrade failed, I tried to reconnect to console and then power cycled. Pressing 'omega-reset' button for 10+ seconds did not reinstall factory code.
Is there a way out this without sending unit back to Omega? There needs to be a more robust upgrade where we get led feedback (or something) during upgrade.