here is what I did.
I put my Omega2+ on an expansion board.
Connected through serial
On a USB drive copied omega2p-v0.1.9-b159.bin
Copied the file to /tmp
Ran sysupgrade omega2p-v0.1.9-b159.bin
It all seemed to go well, I got the prompt back, so I decided to move the chip to a Power Dock. When
moving the chip, it did seem a bit hot.
Booted the omega2+ with power dock and I could ssh to it.
A couple of hours later, the chip was not responding. When I touched the chip it was burning hot, you
could not touch it more than a fraction of a second.
Moved it back to the expansion dock... still dead and getting to hot to touch.
The docks are working fine with other chips.
There are no obvious shorts on the chip, and it was working OK before the sysupgrade
Any idea what went wrong?