Thanks mate! You just saved me a lot of debugging time
Posts made by Oli Woods
RE: Omega2 annotated pinout (including MT7688 pin names)
RE: Cloning an Omega's image
If I were you I'd put those all custom stuff also to the USB drive and install / copy them to Omega2(+) with a little shell script.
Got it, I think this is what I will do.
From yours and Chris's replies I think a custom image would be best avoided!
Cloning an Omega's image
Long time lurker, first time poster.
I’ve been working on a specific project for quite a while now and have got to the point where I would like to make a couple of units.
My question is, whats the recommended approach to clone an Omega's image onto either a SD card or USB so I can then flash it onto other Omegas. Probably over USB with the expansion dock or with the ethernet dock.
I’ve been reading about the dd command which sounds promising:
Am I ok to just go ahead and try doing this over usb with dd? or are there complications with unique MAC addresses etc?
Any help would be much appreciated.