Reply to Does DS18B20 1-wire work on the original Omega? on Fri, 10 Feb 2017 04:37:09 GMT

David Rugh — Fri, 10 Feb 2017 04:37:09 GMT

Following this tutorial using the original Omega and Vktech DS18b20 Waterproof Temperature Sensors
https://docs.onion.io/omega2-docs/communicating-with-1w-devices.html
https://www.amazon.com/dp/B00CHEZ250

Have a 4.7k pullup resistor between the data wire and the 3.3V rail; using pin 14 on the power dock.

I'm just seeing the phantom IDs, not one that looks to be in the correct format.

Shouldn't this work?

Ω-ware: 0.1.4 b330

root@Omega-0B45:~# insmod w1-gpio-custom bus0=0,14,0
root@Omega-0B45:~# cat /sys/devices/w1_bus_master1/w1_master_slave_count
1
root@Omega-0B45:~# ls /sys/devices/w1_bus_master1
00-400000000000 w1_master_attempts w1_master_search
00-800000000000 w1_master_max_slave_count w1_master_slave_count
driver w1_master_name w1_master_slaves
subsystem w1_master_pointer w1_master_timeout
uevent w1_master_pullup
w1_master_add w1_master_remove
root@Omega-0B45:~# cat /sys/devices/w1_bus_master1/00-800000000000/w1_slave
cat: can't open '/sys/devices/w1_bus_master1/00-800000000000/w1_slave': No such file or directory
root@Omega-0B45:~# ls /sys/devices/w1_bus_master1
00-400000000000 w1_master_add w1_master_remove
00-800000000000 w1_master_attempts w1_master_search
00-c00000000000 w1_master_max_slave_count w1_master_slave_count
driver w1_master_name w1_master_slaves
subsystem w1_master_pointer w1_master_timeout
uevent w1_master_pullup

Reply to Does DS18B20 1-wire work on the original Omega? on Sat, 11 Feb 2017 23:30:33 GMT

David Rugh — Sat, 11 Feb 2017 23:30:33 GMT

Ok seems to work if I use pin 1 on the power dock to connect the data line.

There may be restrictions on which pins you can use as GPIOs; this gave a hint:
https://docs.onion.io/omega2-docs/expansion-dock.html

By default, the Serial, SPI, and I2C pins implement these communication protocols and cannot be used as GPIOs. Similarly, the I2S and PWM pins are set to GPIO mode by default.

So I see on the expansion header (different pinout than the power dock) that pins 0 and 1 are associated with I2S so I used pin 1 and that was successful.

root@Omega-0B45:~# insmod w1-gpio-custom bus0=0,1,0
root@Omega-0B45:~# cd /sys/bus/w1/devices/
root@Omega-0B45:/sys/bus/w1/devices# cd 28-041671215aff/
root@Omega-0B45:/sys/devices/w1_bus_master1/28-041671215aff# cat w1_slave
47 01 4b 46 7f ff 0c 10 6c : crc=6c YES
47 01 4b 46 7f ff 0c 10 6c t=20437