We have upgraded the community system as part of the upgrade a password reset is required for all users before login in.

3g Cellular Expansion



  • After following the expansion guide installation and setup, I am having issues with the module connecting to the network.
    Using the 'ifconfig 3g-hologram up' and then 'ifconfig -a' command i get the following for the card:
    3g-hologram Link encap:Point-to-Point Protocol
    UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
    RX packets:0 errors:0 dropped:0 overruns:0 frame:0
    TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
    collisions:0 txqueuelen:3
    RX bytes:0 (0.0 B) TX bytes:108 (108.0 B)
    as you can see there is no ip assigned
    Connecting to the serial port, after the boot up, scrolling about every 10 seconds or so is the message '3g-hologram renamed from ppp0'. this scrolls continuously

    I must have missed something, but I can't seem to locate the issue
    Omega2+ has os 0.2.2 b201
    expansion dock
    2amp power supply
    no other devices or modules attached
    network config, firewall config and chat script (3g.chat) updated per the online guide

    Any suggestions are greatly appreciated.

    Thanks


Log in to reply
 

Looks like your connection to Community was lost, please wait while we try to reconnect.