RGB LED on Expansion Dock

Reply to RGB LED on Expansion Dock on Sun, 08 Nov 2015 02:03:40 GMT

faulty lee — Sun, 08 Nov 2015 02:03:40 GMT

I was looking around for information on the GPIO connected to the RGB LED on the expansion dock, didn't find any, so I tried to traced back using a multimeter. Below is the connection, please correct me if I'm wrong, otherwise at least this should help the next guy looking for it.

1kOhm current limiting resistors are connected to each pin

LED R  - GPIO17
LED G  - GPIO16
LED B  - GPIO15

Set GPIO to 0 to turn on and 1 to turn off. I'm guessing the invert is because most GPIO have better sinking capability than sourcing. I would have expect a slightly different resistor value, especially for Red as each color have different luminosity and to achieve a better "white" when all are turned on.

Below is some code to get started

#Setup export and GPIO direction
echo 17 > /sys/class/gpio/gpiochip0/subsystem/export
echo 16 > /sys/class/gpio/gpiochip0/subsystem/export
echo 15 > /sys/class/gpio/gpiochip0/subsystem/export
echo out > /sys/class/gpio/gpio17/direction
echo out > /sys/class/gpio/gpio16/direction
echo out > /sys/class/gpio/gpio15/direction

#turn off RGB LED
echo 1 > /sys/class/gpio/gpio17/value
echo 1 > /sys/class/gpio/gpio16/value
echo 1 > /sys/class/gpio/gpio15/value

#turn on R
echo 0 > /sys/class/gpio/gpio17/value
#turn on G
echo 0 > /sys/class/gpio/gpio16/value
#turn on B
echo 0 > /sys/class/gpio/gpio15/value

Reply to RGB LED on Expansion Dock on Sun, 08 Nov 2015 02:56:01 GMT

Lazar Demin — Sun, 08 Nov 2015 02:56:01 GMT

Nice! That's some good detective work

We've actually made a tool that can run software PWM to control the colour of the LED. Check out this help desk article.

Reply to RGB LED on Expansion Dock on Sun, 08 Nov 2015 02:58:10 GMT

faulty lee — Sun, 08 Nov 2015 02:58:10 GMT

Lol, I was searching for RGB LED, no wonder I didn't find anything here and at the help desk. That's what I've been thinking, you guys wouldn't have missed such a simple thing.

Reply to RGB LED on Expansion Dock on Sun, 08 Nov 2015 11:22:46 GMT

T NT — Sun, 08 Nov 2015 11:22:46 GMT

Very nice work! Thank you very much. I am so stupid not realising that you needed a 0 to turn it on. Doh! Cheers!

Reply to RGB LED on Expansion Dock on Wed, 11 Nov 2015 03:14:09 GMT

faulty lee — Wed, 11 Nov 2015 03:14:09 GMT

The code for expled used in the help desk article is here https://github.com/OnionIoT/fast-gpio/blob/master/scripts/expled.sh in case someone is looking.