We have upgraded the community system as part of the upgrade a password reset is required for all users before login in.

Ethernet Only



  • I have recently received several Omega2 devices, docks, and Ethernet Expansion. I have a very particular purpose to use the Omega2 as a TCP to Serial device.

    I am a little bit confused in how to use the Ethernet Expansion ONLY as I do not require any wireless capabilities, WiFi or AP.

    I seem to be able to get the Ethernet interface to register (by editing and adding section to /etc/config/network) and get an IP address. My natural instinct from normal linux is to ifconfig xx down , so i disable the wifi and AP interfaces.

    I was not sure what to add in the /etc/config/firewall file, but the current state of my board is i have an IP on the eth0 ethernet interface, but cannot seem to route packets to and from the device.

    I would expect this to be the simplest configuration over all the bridge and router instructions, but perhaps am missing a critical part ? Is it possible to setup for ethernet configuration only ?

    Thanks



  • @john-frailey Sounds like you wish to disable the wifi hardware -

    During a session you can disable wifi with the terminal command line entry "wifi down".

    This change makes the Omega2 always start-up without wifi. Try that edit in the /etc/config/wireless file and let us know if that works for you.



Looks like your connection to Community was lost, please wait while we try to reconnect.