Hi @Lazar-Demin

Do you have any suggestions on how to sort this? Any help would be much appreciated!

Hi @Lazar-Demin,

I have the global model, with the EG25-G module

Thanks!

Hello,

I just received my first Onion device, an Omega2 LTE. I am very happy with the hardware quality but have been totally unable to get the device to connect to my LTE network (EE in the UK). I am totally new to this, but have tried a bunch of stuff including using uqmi to configure the modem and using minicom to send AT commands to the modem to get the status. The modem responds to AT commands, has signal, is connected to EE (although not for data) and has the correct APN stored locally, so I assume it received this when I used o2lte apn.

After 2 days of trying everything I can think of (can't list – or even remember – everything I tried) I have still had no luck. I also ran into the same issue described here, but I don't think this is the cause of my main issue.

Immediately after rebooting the device following o2lte data disable, ifconfig wwan0 shows the device as having an ipv6 address (although when I look this up online it doesn't seem to be a valid public address). If I then use o2lte data enable to start the data connection, ifconfig wwan0 then shows no IP address. (see attachment)

The APN settings for my provider include a username and password, and initially I thought this might be the issue. I still haven't been able to work out how to provide these to the modem, although at this point I don't think that is the problem after trying the sim in Android phone. Whilst the APN username and password populated by default on the phone, deleting these didn't prevent the device from connecting to the network.

Does anybody have any ideas on how I might be able to get my Omega connected to LTE? Would be very grateful for any guidance.

Thank you!