@Lazar-Demin I followed your instructions using an ETH cable and then used option [0] : Web recovery mode

All solved... No need for assistance... thanks

@crispyoz yes, I will need to lwarn how to efficiently juggle the space available

@crispyoz I do not have any devices that are bricked

@thomas166 which binary are you using? Did you try downloading it again and re-trying?

@Lazar-Demin I followed your instructions using an ETH cable and then used option [0] : Web recovery mode

All solved... No need for assistance... thanks

@Lazar-Demin I am trying to use the ethernet web recovery option. I do not understand the instructions in the documentation. I am confused about the sequence of plugging the ethernet cable into my PC and then creating the IPV4 point. I note that the cable should not be plugged into the Omega 2+LTE initially, but if this is the case then how do i Create a new local access point for the device? Please excuse the ignorance as I am not well versed with configuring the LAN details.

This is my boot sequence which seems to indicate that the device found and initialized the eth adaptor??

Just curious why there is not 'Undefined Network' showing ????

@Lazar-Demin I had a read through the cloning info... I have a question regarding the use of USB devices on the Omega 2+ LTE. The device has one USB port which is used mainly for power or serial connectivity with a PC etc. How can I attach a USB drive to the Omega?

@crispyoz yes, I will need to lwarn how to efficiently juggle the space available

@crispyoz sorry,but a bit out of my knowledge level

On a side note... Why does the Omega2+ lte only have 32MB of storage? The only option left is to somehow configure the system to utilize the MicroSD for installation of programs etc. ️

Thanks @crispyoz . I wasn't aware of micro python. Once my ethernet expansion arrives and i can unbrick the device I will install it.. I assume it is available as a package?