@Johan-Erasmus Stupid question, I'm sure, but where exactly is your sample 'hello world' C file in your virtual machine? There's so many directories, even inside ~/omega, that I'm all turned around.
Thanks in advance.
This is all for tonight... I edited line 33 in write-eeprom.py like this:
# time.sleep(0.1) # needs some time to finish write, or fails [Errno 5]
time.sleep(0.004) # datasheet calls for ~ 5 ms wait
Which gives at 32k write time of ~16 seconds.
Sorting out the page write function will make a big difference as well.
After a few hours of banging around, here are some breadcrumbs for the next soul who wanders this way:
The built-in routines only support 8 bit addressing. Full stop.
However, there's a smbus2.py library which can handle larger writes. I grabbed it from here and installed it in the python2.7 directory:
I renamed 'smbus' as 'smbus2' in the two files like this:
bus = smbus2.SMBus(1)
That said, as written it does not currently support page read / page write, merely 16 byte chunks. So it's very slow. I'll see what I can do to speed things up.
I've followed instructions from @UFD to fix the built-in i2c routines and instead allow bit-banged i2c read and write. Thanks for all the work which went in to that post.
I'm attempting to read and write to a 24c512 EEPROM. Its device address is 0b101000. Per the datasheet the device is expecting a 16 bit address for reading and writing. Best I can tell, command line tools i2cget and i2cset are only sending 8 bits worth.
Here's a capture of me reading from device address 0x50, memory location 0x02. The stored data should be 0xAA.
Is there a way to force these in-built routines to use a word-sized address?I've looked here already without seeing anything obvious:
Thanks for your time.
Looks like your connection to Community was lost, please wait while we try to reconnect.