Are you saying about this, under eth0 or wan interface of Omega i need to put above two settings ?
I have same problem.
I had installed opkg install kmod-ledtrig-netdev
Now how i can use above package to configure any gpio for ethernet activity.
I like to know how i can assign any GPIO pin for ethernet activity indication by connecting LED with that.
I need to have link and data LED connected with GPIO pins of Omega2+.
I tried system amber led to show WIFI activity using
echo phy0rx >"/sys/class/leds/omega2p:amber:system/trigger"
but didn't work even. Invalid argument error came.
@Guest Hi, Thanks for explaining in detail. Is your tutorial will work for:
Changing network priority between Ethernet and WIFI.
crispyoz Thank you for the response.
Yes i am new to this field accepted. Does Omega is for only experienced person ? please tell me.
Don't judge me just because i asked you for the help, and listen one more thing till now what ever solution i got from Omega community it was never end to end or complete guideline.
But then also i made good progress on Omega2 by just getting suggestions. I had done mosquitto MQTT and SSL, python based MQTT and SSL. Made SSL with AWS in python and lot more. This all i created. No body from Omega community given ready made code.
I have read almost all post related to my problem on Omega community. From last 3 months i am reading and trying everything. I tried Linkit 7688 then dragino YUN and then started on Omega2.
Don't ever think that i am sitting and asking everything from Omega team.
If you don't want to give response, its ok. But don't say this things
Re: Wireless setup
I had gone through above topic on wireless setup, but could not able to fix my problem. Kindly help.
My problem is:
**How i can change network priority between Ethernet and WIFI.
Thanks, I did as you said. Disabled wireless station mode by going into /etc/config/wireless and rebooted.
After that i tested ethernet plugging and un-plugging many times. Its work and getting identified by omega and registered. Also ping test work. you can see below image
But after enabling WIFI :
How i can change network priority between Ethernet and WIFI. Ethernet need to be at 1st priority. WIFI needed just as fallback network, If ethernet not working then search for WIFI
Please response soon, what i should do next
Kindly explain how i can configure network on Omega2 so that both Ethenet and WIFI should work with auto switching between available active network (ethernet and wifi). And giving ethernet as primary network
I want to achieve auto selection of available active network between WIFI and Ethernet, with Ethernet on 1st priority if both network available.
I was trying to get Ethernet working, but facing issue. Above picture shows that Omega2+ keep trying to setup Ethernet but fails and keep repeating it
I think now it is clear, kindly support.
As i said i am new to the linux environment, so please explain in detail how i can make out.
Looks like your connection to Community was lost, please wait while we try to reconnect.