Physical dimension of dock /expansions
I'm looking for technical documentation, dimensions and mounting hole locations of the docks and expansions.
Too bad, I have got one a few days ago, but cannot find it again since I have seen your post. Most likely I have got it on this forum, but can't even remember :-(
It was showing the dimensions of the Onion Omega.
If you search you should be able to get it. And if I find it again I will share it on this discussion - indeed I need it for my own usage so I have to re-find it :-)
I think it was the size of the omega itself, not the dock
Yes, this is what I had in mind, and sorry it's "only" the Omega. Thanks anyway for the link, because I was going on looking for it with no success...
@admins: Would be great to have some place on the website gathering all information about the product. Maybe it exists already but could not find this repository yet.
We're working on it!
For now, very detailed measurements of the Omega are available:
The same type of drawing will be available for the Expansion Dock next week. Thank you for your patience!
@Lazar-Demin Great :-) Keep them coming!
@Lazar Demin: thanks a lot!
If I may add something: to order the pin headers, I had to check the size of the pins with my caliper, and I can see they are not described on this PDF drawing. So you might add a 0.50mm x 0.50mm size for the pins on it.
Thanks again, and sorry for being a pain :-)
Still no news on the docking dimensions???
We're still working on the Expansion Dock dimensions, expect it in the next few days. A few of us came down with the flu last week so overall progress has been slow!
@Frederic-Baumann it should say
0.50 square typon the second page for the pins. Not a pain at all, we want our info to be 100% correct! :)
Hi @Johan-Simons , sorry about the late response. We have done some technical drawing for some of the PCB's we have, and you can download them here: https://wiki.onion.io/Technical-Drawings/Omega-and-Expansions-Technical. We will be adding more to this page every week.