@Lee-James I found the answer and it works well.

http://community.onion.io/topic/2765/wifi-scan

ubus call onion wifi-scan "{'device':'ra0'}"

@Lazar-Demin Because I printed PCBs wrong hahaha....
Thanks for your reply. I just wanted to know is it possible.

I'm using Omega2 and I wanna use UART1 as system console and UART0 as normal serial port.

Can I do it without custom firmware?

Hello, Onioneers.

on boot, in rc.common, console-install-tool takes too long time, about 1 minute, so running rc.local is delayed.

Is there any way to disable consoleb-install-tool?

Omega2, 0.2.0 b197

@Lee-James I found the answer and it works well.

http://community.onion.io/topic/2765/wifi-scan

ubus call onion wifi-scan "{'device':'ra0'}"

Hello, Onioneers.

"iwinfo ra0 scan" command shows WiFi List around like below:

Cell 01 - Address: 00:08:9F:A5:4C:4C
ESSID: "pureun2015"
Mode: Master Channel: 1
Signal: -256 dBm Quality: 204/100
Encryption: none

Cell 02 - Address: 86:25:19:27:AD:A4
ESSID: "DIRECT-6SC43x Series"
Mode: Master Channel: 1
Signal: -256 dBm Quality: 196/100
Encryption: WPA2 PSK (AES-OCB)

Cell 03 - Address: 32:CD:A7:8C:06:95
ESSID: "DIRECT-XUC470 Series"
Mode: Master Channel: 2
Signal: -256 dBm Quality: 179/100
Encryption: WPA2 PSK (AES-OCB)

Cell 04 - Address: 64:E5:99:CF:DF:BC
ESSID: "taegeon024"
Mode: Master Channel: 2
Signal: -256 dBm Quality: 168/100
Encryption: WPA2 PSK (AES-OCB)

Cell 05 - Address: 90:9F:33:DA:C5:36
ESSID: "Wclean-D"
Mode: Master Channel: 3
Signal: -256 dBm Quality: 193/100
Encryption: WPA2 PSK (AES-OCB)

In Warp Core, every signal is -256 dBm. is this command not available in Warp Core?
Is there another command to scan WiFi in command line?

Hello, Onioneers.

I wonder how to enable WiFi channel 12~14 in 0.2.0 b196

In 0.10.0 b159 , I could set CountryRegion in /lib/wifi/ralink.sh but couldn't in b196

@Lazar-Demin Thank you! I'll try again.

@Jeremy-Begg

I have a same issue. Did you solve the problem?