OMEGA 2+ does not transmit a WIFI signal, don't show WIFI
I inserted the Micro SD in my Onion Omega 2+ and after this I don't have a WIFI signal and can't connect to Omega.
I connect device everything is working (light) but can't connect because the WIFI signal doesn't show, its looks like OMEGA 2+ does not transmit a WIFI signal.
I tried to reboot, factory reset and change the cable and doesn't work.
I can't connect the Omega 2+ to configure its looks like I can't do nothing ...
Can you help me, please ...
@Dionis-Vlas you might want to read up on the reset function which could allow a factory reset. i imagine it is just a matter of shorting 2 pins, FWRST (GPIO38)& GND, if you do not have a expansion dock, for a period of time, probably 10 secs, which will start a factory reset. at least that is the claim in the docs. do a search on "omega2 reset function" or similar
i imagine it is just a matter of shorting 2 pins, FWRST (GPIO38)& GND,
Probably you wanted to write 3.3V VIN instead of GND because of the FW_RST input is active HIGH.
@György-Farkas i checked my notes i keep on these issues and i had posted what was in the notes so i was just plain wrong about the pins, thank you for correcting my mistake.
I just tried, nothing helped with this pins factory reset (GND, 3.3 VIN and FW_RST ) ...
It still doesn't transmit WIFI signal ...
Any idea, what can I do?
Thank you very much guys !
@Dionis-Vlas if you have a usb to serial cable that is 3.3v and not 5v you could try to get a serial connection set up. i think a 4 wire , 3.3v, gnd, tx, rx might allow a serial session. you could get boot messages hopefully and also do a wifi setup at least to see if you can determine problem.