@kevin-Wagner Most probably the USB port of your computer can not provide enough current.
Try another USB port, another computer or try to power your Omega with a good 5V 1A (min 500mA) (wall) adapter.
I just got my Omega2+ yesterday. The Cloud Compile feature seems to still be broken? My job is stuck in the queued state. Can it be possible that this has been broken continuously for the last 5 months?
I assume that the omega does not get (enough) power from the Arduino dock. Any ideas? :)
Did you try out other USB-cables?
Also try to connect a USB connector direct on Mainboard if you use a Desktop computer with a front-controller. As longer and older the cables are, bigger is the possibility to get power loss.
Hi @Brett-Shipes, I'm very sorry about wasting your time. It is our fault for failing to ensure a quality in our manufacturing process. Would you please just try turning the switch with a pin one more time as shown below. If that does not work we will give you a full refund.
The red arrow points to the location where the switch has broken off. What you should try to do is to use the tip of the needle to push it to the right to the ON position. Another thing that I have noticed is that your Omega isn't fully plugged into the dock. So it could be that you have already turned the switch to the ON position, but as a result of the improper connection between the Omega and the Dock, it wasn't able to turn on. So please push the Omega all the way into the Dock before trying to turn the switch with a pin.
Thank you for your patience in dealing with us, and I apologize again for wasting your time.
Hi @Yanir-Nulman, I'm really sorry about the poor quality of the switch. Is your mini dock broken in the ON position? If it is in the OFF position, would you be able to try to switch it to the ON position with a needle? As long as the Mini dock is on the ON position, it shouldn't affect the functioning of the Omega.