Omega2+ Amber LED doesn't even light
-
I just received my Omega and expansion board and I followed the instructions:
I assembled the Omega in the expansion board. I powered it with my laptop ,
turned on the switch and the LED on the expansion board turns on RED for a few seconds, then
it turns off. The LED on the Omega doesn't even blink.I don't know what to do. I tried another cable, another USB port, but I get the same result.
Could it be that Omega arrived damaged ?
-
Have you tried using a power brick instead of the laptop? Not all USB ports are equal.
-
Yes, I have tried but the result is the same.
LEDs do not light up.
And nobody has provided a reasonable cause yet.
-
I tried the following from an Onion article related to the leds but nothing worked:
(for example the mod-ledtrig-morse couldn't be installed)
opkg update && opkg install mod-ledtrig-morse
echo morse > /sys/class/leds/onion:amber:system/trigger
cat /sys/class/leds/onion:amber:system/trigger
echo Hello, Onion > /sys/class/leds/onion:amber:system/message
root@Omega-12D9:~# cat /sys/devices/platform/leds-gpio/leds/onion:amber:system/delay 50
echo 100 > /sys/devices/platform/leds-gpio/leds/onion:amber:system/delayecho default-on > /sys/class/leds/onion:amber:system/trigger
gpioctl dirout 1
echo 100 > /sys/devices/platform/leds-gpio/leds/onion:amber:system/delayecho 100 > /sys/devices/platform/leds-gpio/leds/onion:amber:system/delay
