I am having a *slight* problem with my Omega 2+
-
Basically, my problem is the same as (https://community.onion.io/topic/1191/well-i-think-i-bricked-it-resolved/5), but after a long time (3 hours of waiting), the Omega hasn't booted up. I haven't used it in a while, and the old firmware was something like b163. I had been working fine ever since I got it, and this has been my only major problem as of yet.
A little checklist:
The setup was correct, and it was working before today,
All connection ports are in correctly, and the power connector is fine,
I have an Omega 2+ and an expansion board and a Sandisk ultra 16gb MicroSD card in the chip's slot.I can load up a console, but all I see is
" Failed to Execut"
and then when I press enter it reads out
"Please press enter to activate this console"and then it cycles like that whenever I press a button.
pictures of the device and command line will come soon. I do not believe that the power cable is the problem, I believe it is a hardware or a firmware problem. All help and suggestions are welcome, as I would like to get my Omega (2+) up and running again for a project of mine that needs it or another similar device.
Feel free to ask questions, and I will answer them to the best of my ability
Omega gods, please no RIP my device
-
I am tempted to use a USB firmware install, but I would first like to ask you guys your opinions.
-
@Nicholas-Coles
If I were you, I would flash theomega2p-v0.1.10-b160.binfirmware from USB, continue with a First Time Setup.
Happy Debricking! :slight_smile: