Problem configuring WiFi

Till Klocke

Hello everyone,

I finally received my Onion2+ and so far I'm pretty happy with it (in fact I will probably order some more via Indiegogo). But today I retried to configure my WiFi and network settings, basically so the Onion2+ becomes a simple WiFi-Client in my network, without creating its own AP. I read through the LEDE and OpenWRT documentation regarding networking and wireless and I think I should habe a working configuration but I always end up with the following error messages:

ra0(cfg033579): Invalid mode
ra0(cfg033579): Invalid mode
Interface doesn't accept private ioctl...
set (8BE2): Network is down
ra0(ralink): enable failed

My networking config is now as follows:

config interface 'loopback'
        option ifname 'lo'
        option proto 'static'
        option ipaddr '127.0.0.1'
        option netmask '255.0.0.0'

config globals 'globals'
        option ula_prefix 'fd1d:48c4:7633::/48'

config interface 'wifi'
        option proto 'dhcp'
        option hostname 'omega2p'

And here is my wireless config

config wifi-device  ra0
        option type     ralink
        option mode     9
        option channel  auto
        option txpower 100
        option ht       20
        option country US
        option disabled '0'

config wifi-iface
        option device 'ra0'
        option network 'wifi'
        option mode 'sta'
        option ssid 'Internet-Of-Shit'
        option encryption 'psk2'
        option key 'some-password'

I hope anyone can point me into the right direction where my error is.

Thanks in advance

Luciano S.

Are you living in US ? If not you have to change the Chanel-Settings ... Your router might use Chanel higher 9 (US-default=Chanel 1-9). Easiest way to check is, if you have access to your router, change to a fix chanel between 1+9.

There exists the possibility to edit on the omega config file direct ... i will do this for me ... because mine (Router) is also higher than 9 ... if someone links to the request who shows how to change the config file on Omega i will be grateful ... otherwise i will try to find it out ... small detail ... i still use Omega1.

Mirko Strüßmann

Hi,

as I'm stuck at the exact same point. I'd like to know if you found a solution for this problem?

BR,
Mirko.