I have Onion Omega 2+
I am unable to connect to different WiFi networks when the WiFi network except for WiFi I initially connected to during the setup.

I bricked my device so I had to flash firmware. After flashing latest firmware 0.2.0 b196 I was able to boot up into my Onion Omega. But I don't have the apps I previously had.Like the GPIO controller,servo controller,setting and all.
Is there a way to get them back ? or are they lost forever.

I ended up bricking my device.The hard reset on my expansion dock resulted so.I installed PutTy. Serial Communication didn't work so I had to open terminal and flash firmware.

The CLI also isn't working

I tried it. Yes it works.
https://www.hackster.io/LaurenceHR/wifi-ap-repeater-with-onion-omega-cbc7aa
I want to use it as a repeater. I can't access the options mentioned in the link above.

When I try to open wifi settings in the onion console the circle keeps spinning and nothing opens up? what is the problem? I performed a factory reset and the problem persists. But I am able to connect to the wifi initially after performing a factory reset.

@brolly759

@brolly759 I guess the for mic functionality there are an additional 2 more wires.

I have a USB camera(iBall face2face)which also supports mic.I cut the USB end and soldered each wires in the USB cable with female jumper wires.I want to interface it with the Onion Omega2(any development board).The camera cable consists of 6 wires.

Red - Supply
Black - Ground
Blue,Yellow, Green & White.

I don't know the scheming for other wires but I supposedly think there should be a transmitter and receiver lines. I tried all combinations but it doesn't connect or show up any video or image even while testing connections on Windows laptop?How should I connect it and be able to use it capture images and videos on Onion Omega

see the micro usb is for powering the device right.
can we add peripherals to it?