Thank you guys for the reply, I manage to update the firmware to 19.07.6 and then all package installation worked fine thru opkg. I have now a Omega 1 running with OpenVPN client, ser2net and 4G dongle.
Regards

Looking at the schematics I don't see anything between CPU and LTE module, so that answer my question. I will have to build my own module then.
https://github.com/OnionIoT/Omega2-LTE/blob/master/Hardware/R1.1/Omega2-LTE-v1.1-Schematic.pdf

Hello @jossvall, I didn’t doubt that the CPU offers, but the board doesn’t seems to, my guess is that the port is been used by the LTE module incorporated. If that is the case my solution would be making my own pcb adding a hub between CPU and LTE module, so I can add more devices.
Thanks for the input.

Thank you. The idea is to remote to a device over Serial, so this v1 board did the trick. But I'm looking in upgrading this, using the Omega2 LTE, but I was looking at the specs and it doesn't seems to offer the USB Host port, it's been used by the LTE module?

Thank you guys for the reply, I manage to update the firmware to 19.07.6 and then all package installation worked fine thru opkg. I have now a Omega 1 running with OpenVPN client, ser2net and 4G dongle.
Regards

In any case, I can't seem to find any information about crosscompiling for V1

Hello, I have a Omega V1 running Chaos Calmer, and while trying to install some packages I'm getting:

• satisfy_dependencies_for: Cannot satisfy the following dependencies for openvpn-openssl:
  *kernel (= 3.18.23-1-b2f200610f46d20ef52d269421369d0c) *
  I'm running Linux Omega-1468 3.18.36
  What should I do here, compile the package for this kernel, or recompile the image with the module included?

@Janus-Sanders I did try insmod "module", but the command console doesn't come back anymore, stop responding, and after a few tries I bricked the Onion. Just waiting to solve this brick problem to come back to the modules issue.

@Lazar-Demin Hi, my second Omega is on shipping right now, I will try as soon as I receive. But with chip is used in your ethernet expansion, any chance that I could use a enc28j60 based ethernet module as a eth expansion?

I'm trying to install some modules from a differente kernel 3.18.20. Ok, I can get to uboot, but I don't have a ethernet expansion. Any way to flash it by serial?