I'm trying to use RX1 and TX1 for UART communication and I can't get it to work.

RX2/TX2 works fine.

Investigating this issue I found that in contrast to the documentation, Pin45 seems to be sending instead of Pin46.

Before I start tearing up a clean and completely soldered selfmade breakout-board in order to change these lines, I would like to confirm that this is an issue and can not be resolved by setting a different bit somewhere.

@UFD Thanks for the link! Good to know that it already exists, I will test ASAP.

I might need a second I2C in my project because of I2C address conflicts. Is it possible to use the I2S (which I do not need) to work as I2C? Or is there any other lib that can make the Omega2 have 2 times I2C?