Failure again.

P44-ledchain only allows PWM channels 0-3, thus it would not let me load the module when I try UART1 (PWM01) or UART2(PWM23)

Runnning out of ideas and frankly frustrated.

The Power expansion board seem to be my limiting factor.

Any help would be appreciated

I think I found the problem. I'm using PWM0 but in the Expansion board those seem to be GND.

I'm going to try to use UART1 as PWM. I will need to reconfigure the module (91-p44-ledchain to point to ward UART1 (PWM01)

Then I should be able to use TX1 as the Data line for the Ledchain.

Will report back

Gents, having some issues with the P44 module to control a Ring of LEDs

https://www.amazon.ca/gp/product/B0774JNSCF/ref=ppx_yo_dt_b_asin_title_o01_s01?ie=UTF8&psc=1

It is connected to the Omega2 via the expansion module to GPIO18

I belive everything in the omega is configured. I'm starting to suspect that the issue is with the expanison module.