Posts made by Nate Pink

Thanks. Ordered one and will revisit when it arrives.

I'm probably doing it wrong (plugged in to computer with switch off, held button down and turned on).. but when I hold the button down, it gets to about 10 seconds and then launches the u-boot netconsole:

• U-Boot 1.1.4 (Sep 14 2015, 08:21:31) *

AP121 (AR9331) U-Boot for Onion Omega

DRAM: 64 MB DDR2 16-bit
id read ox100000ff
FLASH: 16MCLOCKS: 400/400/200/20 MHz (CPU/RAM/AHB/SPI)

LED on during eth initialization...

Press reset button for at least:

• 3 sec. to run web failsafe mode
• 5 sec. to run U-Boot console
• 7 sec. to run U-Boot netconsole

Reset button is pressed for: 10

Button was pressed for 10 sec...
Starting U-Boot netconsole...

I'm not sure exactly. The oupgrade returned some error and i poked around trying to see if I could do anything and then rebooted it. Maybe a minute or two?

Hi,
After update I'm getting a kernel panic on boot. Attached is the output of the boot sequence. screenlog.0

I connected my Omega today for the first time. I ran through the getting started stuff. I then connected to the console and did a 'oupgrade -check', which reported that there was an upgrade available. I ran 'oupgrade' and the update started. It then said something about not being able to write to something and I failed to take a screenshot of that. It left me at a place where I couldn't run anything (ie 'ls').

I reboot it by unplugging and plugging back in the usb cable. It didn't come back up so I attached via screen and saw the attached file.

Any thoughts on how I can get this back online?

I don't have an ethernet expansion port, which seems like one way to do it.
UPDATE: Perhaps over the serial connection?