However I would like it to be a custom image. I've got about 5 python modules, a couple of python and sh scripts as well as a modification to the .etc file which I would like to include.
Just found out you can get hostapd to show more debug messages, this is what I'm currently getting:
root@Omega-92CA:/etc/config# hostapd -d /etc/hostapd/hostapd.conf
Configuration file: /etc/hostapd/hostapd.conf
nl80211: 'nl80211' generic netlink not found
Failed to initialize driver 'nl80211'
wlan0: interface state UNINITIALIZED->DISABLED
hostapd_free_hapd_data: Interface wlan0 wasn't started
And this is my hostapd.conf file:
I’m trying to enable WPS on an Omega 2 for a project I’m working on (it won’t be triggered by a button, so apparently a little more secure). There’s quite a bit of information online on how to do this for OpenWrt, basically you:
I’ve worked out that before running the above, the lede-project repos need to be re-enabled for OPKG, by modifying the /etc/opkg/distfeeds.conf file, which is fine.
However, when I run: hostapd_cli wps_pbc , I get “Failed to connect to hostapd - wpa_ctrl_open: No such file or directory”.
I’ve read that problems can be caused by the /etc/hostapd/hostapd.conf file. However, I’m missing the whole /etc/hostapd directory…
Would someone be able to shine some light on this for me? Or point me in the right direction.
Thanks mate! You just saved me a lot of debugging time
If I were you I'd put those all custom stuff also to the USB drive and install / copy them to Omega2(+) with a little shell script.
Got it, I think this is what I will do.
From yours and Chris's replies I think a custom image would be best avoided!
Long time lurker, first time poster.
I’ve been working on a specific project for quite a while now and have got to the point where I would like to make a couple of units.
My question is, whats the recommended approach to clone an Omega's image onto either a SD card or USB so I can then flash it onto other Omegas. Probably over USB with the expansion dock or with the ethernet dock.
I’ve been reading about the dd command which sounds promising:
Am I ok to just go ahead and try doing this over usb with dd? or are there complications with unique MAC addresses etc?
Any help would be much appreciated.
Looks like your connection to Community was lost, please wait while we try to reconnect.