Erased all flash by mistake - bricked it!
-
Tinkering after a long break, mine wasn't booting successfully, so I went to the uboot mode (think that's right) and rather than try the ethernet TFTP, I accidentally erased all the flash!
Totally dead now, no led, no uboot. Ordered a new one, assuming all is lost.
The comm connection is active but with zero receive.
-
Just keep the reset button preset when switching on. You should get back to u-boot menu. But you will need a Ethernet extension board to debrick your Omega:
https://wiki.onion.io/Tutorials/Reflash-The-Firmware-With-Ethernet-Expansion
-
I've held it a full minute and got no response on the serial line or any LEDs. Comm handshaking is ok, and the ring? LED is blinking.
I wonder if there is a way to get the. bin file in using the SPI lines on the chip?
How does "the factory" program them?
-
Wich dock are you using? Is it fully connected to the doc (from the side the pins should not be visible)?
-
@Luciano-S. I think he is saying the SPI on the FLASH, like using the pins with some kind on microcontroller to put the image there.
