I've followed the setup steps, and finally got the setup code accepted using the terminal command line.
However the Omega remains offline no matter what I try.
I've got good IP addresses, one DHCP ethernet adapter, and the normal 2 IPs.

Comments appreciated.
Bo Barry
Harrisburg, NC

I've held it a full minute and got no response on the serial line or any LEDs. Comm handshaking is ok, and the ring? LED is blinking.

I wonder if there is a way to get the. bin file in using the SPI lines on the chip?
How does "the factory" program them?

Tinkering after a long break, mine wasn't booting successfully, so I went to the uboot mode (think that's right) and rather than try the ethernet TFTP, I accidentally erased all the flash!

Totally dead now, no led, no uboot. Ordered a new one, assuming all is lost.
The comm connection is active but with zero receive.

@Bo-Barry got it loaded, now don't know to 'run it'. First time PHP.

Any update on this? My first project and it crashed as in the previous comment.

Off to find another project to try, I guess. Bo