@Chris-Stratton I have only had 2 fresh/blank Omega2 units to test with, but for some reason the completely new Omega will not power up in my production board. It's likely due to the fact that there is some pullup/down resistor on a GPIO preventing the Omega2 from starting up. So as a fix until I figure that out I wanted to Zif the Omega2 into a blank version of my board with only power and network connectivity. While there I will go through the initial start up of the Omega2. Then transfer it to it's final production board for the rest of the updating. However, pogo pins is a good idea. I could build a board with a verison of a pogo pin mean to contact a male header pin.