3g Cellular Expansion
After following the expansion guide installation and setup, I am having issues with the module connecting to the network.
Using the 'ifconfig 3g-hologram up' and then 'ifconfig -a' command i get the following for the card:
3g-hologram Link encap:Point-to-Point Protocol
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
RX bytes:0 (0.0 B) TX bytes:108 (108.0 B)
as you can see there is no ip assigned
Connecting to the serial port, after the boot up, scrolling about every 10 seconds or so is the message '3g-hologram renamed from ppp0'. this scrolls continuously
I must have missed something, but I can't seem to locate the issue
Omega2+ has os 0.2.2 b201
2amp power supply
no other devices or modules attached
network config, firewall config and chat script (3g.chat) updated per the online guide
Any suggestions are greatly appreciated.