How to Connect to the Omega’s Command Line
-
@Crazi-Tane I would try as factory reset then start again, I suspect you have got yourself tied in knots.
-
@Crazi-Tane Yes. Factory reset - long press the RESET BUTTON of Expansion Dock - is a good idea, give it a try.
You wrote about the amber LED "... turns on and then starts flashing. After a while it stops flashing"
And ... does it stay ON or OFF?Try to connect to the Serial Console. It's a very useful troubleshooting tool. Serial on a Mac Device
-
Thanks gyorgy, I will do both of the things that you suggested.
The LED stays on.
-
@crispyoz Thanks crispyoz
-
Also guys, when I factory reset, will there be any thing to let me know that the omega has factory reset. Like a light or something?
Thanks a lot
-
@Crazi-Tane when the Omega is performing a factory reset, the LED will flash rapidly while the restore of the factory firmware is being performed, then it will reboot and as it boots the LED will flicker as per a usual reboot process.
-
@Crazi-Tane The amber LED of your Omega2+ is ON - it's a good news.
Press and hold down the RESET BUTTON as long as the LED starts blinking very quickly and hopefully it's performing a successful factory reset.
After just over one (1) minute the amber LED remains ON and - a little bit later - you should find the Omega-ABCD WiFi AP.Good luck.
-
Thanks guys so much will try tonight
-
IT WORKED!!!!
Thank you guys soo much for the help. I will try to send a little than you gift your way.
-
@Crazi-Tane Good news!
-
This post is deleted!
-
@Crazi-Tane the best gift you can give is to pay it forward. Look at new posts and if you can help answer the question contribute your expertise.
-
I will do that thank you very much guys
-
@Crazi-Tane The positive feedback confirming that it worked was all the gift we needed.
-
Thanks gyorgy