U-Boot fresh build
I'm pretty new to Onion Omega2, but I'm wondering if it could be possible to build and flash Omega2 board with a fresh U-Boot release taken from the U-Boot official repo.
I've a mips cross compiler and U-Boot official sources, make menuconfig already done and stucked at the point to provide a .dts configuration for the target board.
Thanks a lot.
crispyoz last edited by
@multix85 dts files are in ~/source/target/linux/ramips/dts you can find the source to the Omega2(+) uboot in their github:
I wonder why you need to build a new uboot, are you sure you do?
Hi @crispyoz, thanks for helping...
I'm trying to build a fresh original u-boot with I2C support enabled. So I need to rebuild official u-boot because I cannot find any evidence of I2C support in Onion bootloader Ralink BootLoader 184.108.40.206 (the same you linked).
I found Omega2p dts files in OpenWrt source code:
I think one possibility to build the official U-Boot firmware for Omega2p is to create a new board configuration using this two:
Do you think I'm on the right track?
Thanks a lot