Omega 2+ auto-mdi-x support
I'm using a Omega2+ on a custom board with a SI-46020-F MagJack RJ-45 port connected to the omega's ethernet pins.
If I connect my laptop with a cross-over ethernet cable, I can SSH into the omega. But if I use a straight-through ethernet cable I cannot.
The RJ-45 port I'm using supports auto-MDIX, is there a way to enable this on the omega's side? Ethtool doesn't seem to be fully supported:
Settings for eth0:
Cannot get device settings: No such device
Current message level: 0x000000ff (255)
drv probe link timer ifdown ifup rx_err tx_err
Link detected: yes
crispyoz last edited by
@arcozelo I think it would be helpful to post the schematic of your custom board. Both cables will work with the ethernet expansion so you should check you have implemented per the design guide.
We have solved the problem with the help of the Hardware Design Guide. Thank you.