We have upgraded the community system as part of the upgrade a password reset is required for all users before login in.

Password?



  • I am trying to login to the Omega board using Putty, does anybody know what the password should be
    I tried the password from Getting Started - "onioneer" but does not work for root.



  • Ok I'm no expert but I tried the tutorial using putty and it didn't ask me for a login.
    Once serial connection is established using the expansion dock you should see the boot data if you cycle the power and eventually the command prompt.



  • I have another problem in that I do not get any WiFi (see earlier post)

    But if I use Putty and start the Omega through Com3 I get this

    ehci_reset Intialize USB CONTROLLER in host mode: 3
    ehci_reset Port Status 1c000000
    ar7240-ehci ar7240-ehci.0: irq 3, io mem 0x1b000000
    ehci_reset Intialize USB CONTROLLER in host mode: 3
    ehci_reset Port Status 1c000000
    ar7240-ehci ar7240-ehci.0: USB 2.0 started, EHCI 1.00
    usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
    usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
    usb usb1: Product: ATH EHCI
    usb usb1: Manufacturer: Linux 2.6.31--LSDK-9.2.0_U11.14 ehci_hcd
    usb usb1: SerialNumber: platform
    usb usb1: configuration #1 chosen from 1 choice
    hub 1-0:1.0: USB hub found
    hub 1-0:1.0: 1 port detected
    Initializing USB Mass Storage driver...
    usbcore: registered new interface driver usb-storage
    USB Mass Storage support registered.
    **** drop_caches_sysctl_handler: all done timer added ...****
    Starting pid 218, console /dev/t
     (none) mips #6 Fri Aug 28 16:51:14 CST 2015 (none)
    (none) login:
    

    I think this is the login to the Linux OS



  • Hi @Scott-Jordan, as mentioned in the other post, your Omega seems to have the wrong firmware flashed. Can you try logging in with the password admin. Once you've logged in, we can figure out ways to flash it with the correct firmware.



  • I have the same issue and I'm currently making a new topic for it (Lazar asked me to do this after I first posted to the ticketing system).

    A friend and I managed to hack into the omega by interupting the boot sequence an replacing init with sh. Then we were able to see the crypted password, wich in turn googled to the string '5up'. This seems to be the OpenWRT standard root password.

    So try to log in with: root & 5up


Log in to reply
 

Looks like your connection to Community was lost, please wait while we try to reconnect.