Posts made by Ankit Rana

Re: Omega continously Booting cant find access point

Now i'm powering onion omega with LD 1117 ic using this document

https://docs.onion.io/omega2-docs/hardware-prep-no-dock.html

but still the LED is blinking for some time and again it continue, omega complete booting process.
and i cant find access point at all.
and i had tried various supply they are giving exact 3.3,
and i don't think there is a problem with slight higher current!!

Please give me a way to use this "ONION OMEGA", i had invested too much time.
but the output is zero.

@Maximilian-Gerhardt @György-Farkas thanks for your reply, no I do not have any Dock and as you know the omega docks are costly and can't afford them right now.

by the way, I'm powering omega2 using 3.3 and GND pins of USB TO TTL converter.
and on the serial, I'm getting that output. but I can't find access point of omega.

many of other say its power supply fault. but this USB to TTL giving exact 3.3 v and 500ma current that's enough for the board.

and can you please check that serial output ??

Hello there,
I know this problem is common and old but still, I can't find a proper solution for this.
so the scenario is I recently bought onion omega 2.
powering it using USB to TTL.
first onboard LED is glowing then it's blinking (booting) and again and again this thing is happening.
so what is the problem here?
and because of this, I can't find ACCESS POINT of OMEGA.
So I'm unable to proceed further. can anyone guide me.??
I also connect omega with serial pins and on a putty terminal.
I'm getting output like this.