Thank you @Enrico Trevisanello!

The following worked for me:
uci set samba.@samba[0].interface='eth* [YOUR_CLIENT_IP]/[SUB_NET_MASK]'
uci commit samba
/etc/init.d/samba restart

I'm currently on 0.1.9 b150 firmware if that helps.

Thank you @Enrico Trevisanello!

The following worked for me:
uci set samba.@samba[0].interface='eth* [YOUR_CLIENT_IP]/[SUB_NET_MASK]'
uci commit samba
/etc/init.d/samba restart

I'm currently on 0.1.9 b150 firmware if that helps.

Remove the old key in the .ssh/known_hosts file for 192.168.3.1, that will allow you to ssh without error.

@Massimiliano-Scordamaglia

First I had to degrade my 2.4mhz wifi to 54mbs only and disable 20/40 MHz Coexistence, then reboot the router. You also might change your wifi channel to a static 6 or 9 to make sure your not on channel 13. Second, I had to RESET my onion using the dock (first reset didn't work, did it twice, worked second time), start the wizard and try to connect to your wifi network.

The wifi setup FAILED for me every time but when I ssh into the onion (http://192.168.3.1) wifisetup didn't work for me until the wizard failed the first time for some reason. Once the interface was up and I rebooted then it would grab an IP address on the wifi interface.

After I was able to ssh in and connect via wifi I manually did the oupgrade command to the latest p149 version. After that was successful, I then downloaded the latest p150 and scp'd the file to the onion and did a manual upgrade. After the final upgrade to p150 I was able to manually install the console.

My wifi, ethernet, console, and SD card are now all working correctly. The only thing left is connecting to the cloud. I'm able to register but the cloud shows my device as disconnected....

Hope that helps!

I just received my onion 2+ day before yesterday and after upgrading to firmware version 0.1.9 b150 manually my 64GB SD now mounts in /tmp/mounts

Note: 0.1.9 b149 did not work for me.