UPDATE: It turns out we had an issue in our PCB design that was causing electromagnetic noise. This was resetting the USB HUB.
usb 1-1: USB disconnect, device number 2
The issue was not in the camera but in the PCB design affecting the USB HUB
Hey, I got this...
Any ideas about how to fix these files?
[ 12.617020] jffs2: notice: (440) jffs2_build_xattr_subsystem: complete building xattr subsystem, 3 of xdatum (3 unchecked, 0 orphan) and 77 of xref (1 dead, 0 orphan) found.
[ 12.632902] ttyS ttyS0: 14 input overrun(s)
[ 12.637989] block: attempting to load /tmp/jffs_cfg/upper/etc/config/fstab
[ 12.653221] block: extroot: not configured
[ 12.953289] jffs2: notice: (438) jffs2_build_xattr_subsystem: complete building xattr subsystem, 3 of xdatum (3 unchecked, 0 orphan) and 77 of xref (1 dead, 0 orphan) found.
Hey @Dzuy-Nguyen did you fix it? I'm having a similar problem here...
@crispyoz Thanks. That makes sense because we (by default we all) are using bridged AP mode https://openwrt.org/docs/guide-user/network/wifi/bridgedap
I'm going to try to setup my onion as a router AP https://openwrt.org/docs/guide-user/network/wifi/routedap and I'll let you know guys...
@Lucas-Gozalvez I was powering my omega via a laptop. Now i connected it to power supply. After that also, i am still unable to capture any image from the webcam.
I see the error in dmesg as below:
what I mean is to connect the USB camera to a USB HUB (powered) and then the USB HUB to Omega Onion
@Anil-Kulkarni I think you might have a power-current issue. It seems your camera is disconnecting . Can you please try to connect the camera via a powered USB HUB?
Looks like your connection to Community was lost, please wait while we try to reconnect.