Posts made by SYLVAIN MAILHIOT

Thanks @Steffen-E , I will check this out later tonight

I have the same issue with bootloader.lua

Sketch uses 1,030 bytes (3%) of program storage space. Maximum is 32,256 bytes.
Global variables use 9 bytes (0%) of dynamic memory, leaving 2,039 bytes for local variables. Maximum is 2,048 bytes.
ash: merge-sketch-with-bootloader.lua: not found
Flashing application '/tmp/sketch.hex' ...
Error: Write failed
Done
Flash complete!
failed to switch to bootloader (invalid address?): No such device or address

I'm connecting to the arduino expension board using micro usb. I was able to flash it multiple times. Somehow, it stopped working

Any tip ?

Done! come on!! we need more ppl

Cooler IoT - Smart Cooler Solution 60%
Onion Omega 22%

@Frederic-Baumann
I found this on amazon : http://www.amazon.com/Single-Straight-Female-Header-Socket/dp/B00GYRN1J0

maybe you can contact the seller

I think this is what you are looking for :
https://www.sparkfun.com/products/11376

Is your expansion working if you use the console ?

I would like to participate by reviewing what is written to make sure is easy enough to be understood by a newbie

@Lazar-Demin

Seems that was working.

I didn't took the chance to connect the arduino dock when the omega was live.

this is my result :

[.....]
Reading | ################################################## | 100% 0.00s

avrdude: verifying ...
avrdude: 1 bytes of lock verified

avrdude: safemode: Fuses OK (E:05, H:DA, L:FF)

avrdude done. Thank you.

Nobody ?

I would just use a standard Relay that can manage that power and be driven by the relay expansion. my 2 cents

Hi folks,

I'm following this guide : https://wiki.onion.io/Tutorials/Arduino-Dock/Initial-Setup

Unfortunately, I am not able to use my Omega & Expansion dock as a programmer.
(https://wiki.onion.io/Tutorials/Arduino-Dock/Initial-Setup#arduino-dock-setup_using-the-omega-expansion-dock-as-a-programmer)

I did all the wiring as proposed and when I connect the micro-USB, the Omega isn't booting, the led on the arduino dock keep flashing and I can't access my Omega through Putty.

My version is 0.0.6 b266

What am I missing ?

I followed this tutorial :
https://wiki.onion.io/Tutorials/How-To-Install-LAMP-Stack-on-the-Omega

and this is the error message I have when I try 192.168.3.1:9000

Forbidden

You don't have permission to access /php/php-cgi/index.php on this server.

content of my httpd.conf different from the tutorial :
Listen 192.168.3.1:9000
ServerName www.calem.com:9000

More info: I can load my console at 192.168.3.1

Any hint for me ?

Thanks!

@SYLVAIN-MAILHIOT said:

Would you have the GPS and Bluetooth ready? Still waiting to receive them.

I did followed that tutorial except I didn't install mySQL. I will do it again. Thanks

Hi !

I followed the tutorial here : Tutorial

It seems that my web server is up cause I can see the php file using my internal IP and port, but I see the php content in my browser instead of executing the code.

What am I missing ?

@administrators This thing can happen.. don't worry!! Would you have the GPS and Bluetooth ready? Still waiting to receive them.

Same shipping address yes. Thank a lot!

I was looking at my Arduino dock and it seems that it's missing a connector for the onion omega.

If it's the case.. what should I do ?

Picture