john frailey last edited by
I have recently received several Omega2 devices, docks, and Ethernet Expansion. I have a very particular purpose to use the Omega2 as a TCP to Serial device.
I am a little bit confused in how to use the Ethernet Expansion ONLY as I do not require any wireless capabilities, WiFi or AP.
I seem to be able to get the Ethernet interface to register (by editing and adding section to /etc/config/network) and get an IP address. My natural instinct from normal linux is to ifconfig xx down , so i disable the wifi and AP interfaces.
I was not sure what to add in the /etc/config/firewall file, but the current state of my board is i have an IP on the eth0 ethernet interface, but cannot seem to route packets to and from the device.
I would expect this to be the simplest configuration over all the bridge and router instructions, but perhaps am missing a critical part ? Is it possible to setup for ethernet configuration only ?
Ken Conrad last edited by Ken Conrad
@john-frailey Sounds like you wish to disable the wifi hardware -
During a session you can disable wifi with the terminal command line entry "wifi down".
This change makes the Omega2 always start-up without wifi. Try that edit in the /etc/config/wireless file and let us know if that works for you.