My Omega 2/2+ dock\new
-
@Douglas-Kryder
Check that you have 3.3v on the correct pins prior to inserting the omega in the dock!
-
Is it available for purchase? Assembled / soldered one.
-
@valerionew said in My Omega 2/2+ dock\new:
@Douglas-Kryder
Check that you have 3.3v on the correct pins prior to inserting the omega in the dock!yes. in my case it is ~3.265v. once i got headers in and checked, put an omega2+ in it powered up ok. i attached a 250GB hard disk to usb and it was recognized then i plugged in ethernet and ifconfig reports it available. at this point decided to take a break from it and will pick up tomorrow or Sunday afternoon. i need to review & read some more. but, thanks valerionew for creating the dock\new and your help as i built my first one. i appreciate it. doug
-
@Sekar-Pdkt
Contact me via PM, i may have one or two assembled
-
@Douglas-Kryder
Today i've done a factory reset. To respond to your question about setup: you'll also need to follow this guide https://docs.onion.io/omega2-docs/using-ethernet-expansion.html#using-ethernet-expansion to set up internet access via ethernet.
-
@valerionew , yes, you are correct. prior to building a copy of your dock\new i had used a simple rj45 dongle thru usb on expansion dock. first tim i plugged it in i was surprised a bit that omega2+ had recognized it but i found that the action on that web page you link was necessary for the dongle so in building the dock\new i assumed it would be necessary but i was not positive. anyway, thank you for mentioning it.
-
@valerionew Any update on the project?
-
@Valerio-Backslashnew Any updated on the project?
-
@Wojciech-Kapelinski The project is released on github, at the moment i'm not planning to do any new version
-
It is awesome. Functional and small. If your project no need to GPio it is perfect for connectivity. USB + wifi + ethernet.
The next version you can add usb to serial converter for connecting Omega2 on USB OTG.
CH340e
https://www.cnx-software.com/2017/10/31/wch-ch340e-is-a-tiny-10-pin-serial-to-usb-chip/I think you can place it under RJ45 conn or move lm1117 a bit and place there . RX TX and OTG usb d+ and d- pin you need.
Good working.
