Can't connect omega2 after oupgrade
Hello I bought omega2 from Kickstarter campaign. I did not used it long time and now I tried to make an update so I logged in via ssh and hit oupgrade. After a while my ssh connection dropped and after a while there was no omega AP. Now after reconnecting it to 3.3v omegas LED is on and after 10s starts blinking and after 25s LED is always on.
No wifi AP, not connected to wifi.
How can I make it work? I have no dock.
But I have bunch of arduinos and raspberries
Thanks for any help
@Michal-Kajaba have you tried a factory reset?
When you say you have no dock, how are you powering the device?
@crispyoz simply through VIN and GROUND pin
@Michal-Kajaba Take a look at this post on how to wire a switch for factory reset.
@crispyoz I connected fw reset pin with 3.3v for 10s during boot process and omegas AP is up. So it looks it worked!!!! And firmware is the newest 0.3.2
Thank you very much
@Michal-Kajaba Good news
I have the same problem. Today my Onion Omega2 + arrived, I followed the initial procedure, updated the firmware and now my wifi no longer works: the Onion Omega cannot connect to my home WiFi and I can't even see its WiFi from a PC or smartphone .
@AlessandroNemesi Have you tried the factory reset procedure?
What if any dock are you using?