I2C Potentiometer AD5245

[DumTux]

On my board, I made an adjustable power supply for external devices.

It is connected to I2C bus of Omega2S+, and I could see it's present correctly.

root@OpenWrt:~# i2cdetect -y 0
     0  1  2  3  4  5  6  7  8  9  a  b  c  d  e  f
00:                         -- -- -- -- -- -- -- -- 
10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
20: -- -- -- -- -- -- -- -- -- -- -- -- 2c -- -- -- 
30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 
70: -- -- -- -- -- -- -- --                         
root@OpenWrt:~#

On the Analog Devices Wiki post, there's insturctins how to setup the driver.
I ran make kernel_menuconfig and customized the kernel for supporting AD's I2C potentiometer devices.

Device Drivers  --->
  [*] Misc devices  --->
    <*>   Analog Devices Digital Potentiometers
    <*>     support I2C bus connection
    < >     support SPI bus connection

After compiling and flashing I expected that I could see the three EEPROM setting devices as AD's wiki says.

# ls /sys/bus/i2c/devices/
0-0022  0-0027  0-002f

But I could only see this.

root@OpenWrt:~# ls /sys/bus/i2c/devices/
i2c-0
root@OpenWrt:~# 

Controlling AD5245 by I2C commands is not that complex, and it won't be much difficult to port some Arduino or MicroPython library into a small Python lib for Omega2.
But it would be great if I can use the native Linux driver.
What am I missing in configuration?

[BerthaH]

This post is deleted!