Arduino dock setup not working
-
@Lazar-Demin I noticed that the wiki article mentioned that the message shouldn't be an issue, but it keeps prompting me for the password. I hadn't changed it from the default password, so I would enter the default and then it would just ask me again to enter my password. I also tried pushing the MCU Reset button after entering the password, but it still just prompted me again for it.
-
Also, I can't wait for my Omega2 and the Arduino Dock R2! I'm very excited!
-
@Peter-Natale Can you try flashing a sketch using the Omega? That should work!
-
@Lazar-Demin --
root@Omega-0C8B:~# sh /usr/bin/arduino-dock flash blink2.ino.hexFlashing application 'blink2.ino.hex' ...
Error: Write failed
failed to switch to bootloader (invalid address?): No such device or address
Done
-
@Peter-Natale can you check if you can see on the Omega:
device :/dev/i2c-0(address: 0x29)Did you try this with the MCU_RESET button?
-
@Luciano-S I didn't have much time to try it, but I did notice that the LED on my arduino dock is not turning on.
-
@Peter-Natale Looks like the ATmega isn't responding to being put into Reset via I2C. This is most likely because the last sketch that was flashed did not include the Onion Library that sets up the I2C reset method.
From the Using the Arduino Dock article on the wiki:
(If your previous sketch did not include the Onion Arduino Library you will have to press the MCU_RESET button on the Arduino Dock just before pressing Enter for the arduino-dock command)
As @Luciano-S mentioned, try using the MCU_RESET button before flashing the sketch.
-
Huzzah! It works now! I think a problem I was having was that i was using an older version of the Arduino IDE, and then I upgraded to 1.6.10 which was giving me issues regarding the uno.upload.via_ssh=true line. But now that I installed 1.6.6, I got it to upload normally.
-
After a whole day trying my solution for the following ERROR
failed to switch to bootloader (invalid address?): No such device or address
This occurred via the Arduino IDE and using the Onion Command LineMy hardware is Original Onion Omega + Original Arduino Dock
(Any communication with Onion results in "We suggest you upgrade to Onion2")Anyway I eventually found a very concise instructions @ [https://onioniot.github.io/wiki/Tutorials/Arduino-Dock/Initial-Setup](link url)
It would appear that it must be configured by burning a new bootloader the very first time.
The second method worked for me i.e. Using the Omega + Expansion Dock with the Arduino Dock ICSP HeaderAnd after that I was able to use the Arduino IDE to program the Arduino Dock.
Now the question is can I communicate via the Onion and the Arduino Dock i.e can a program on the Onion use the Arduino I/O Pins?
And can the two communicate via Serial?
-
Q: Onion (LEDE/OpenWRT) <-> Arduino
A: Use Firmata.
