@Lazar-Demin Thanks. we had issue with USB detection.
naveen_kumar
@naveen_kumar
Best posts made by naveen_kumar
-
RE: Omega2s+ and EG25-G Interface error: ifconfig: SIOCGIFFLAGS: No such device error
Latest posts made by naveen_kumar
-
RE: is it possible to use EC200U GSM module instead of EC25 with omega2+
Hi @akhileshthorat @Lazar-Demin
So far,- USB Detected successfully,
- AT commands are working over /dev/ttyUSB2
Problem: raw ip mode is not able to enable
root@Omega-ED9D:~# o2lte data enableEnabling LTE data connection
ifconfig: SIOCGIFFLAGS: No such device
/etc/rc.common: line 1: can't create /sys/class/net/wwan0/qmi/raw_ip: nonexistent directory
Donedoes EC200 supports raw Ip mode? Am I missing anything here?
Thanks,
Naveen -
RE: is it possible to use EC200U GSM module instead of EC25 with omega2+
@akhileshthorat USB Interface. My understanding is, the existing omega2-lte-base package uses USB. I am trying to use same.
-
RE: is it possible to use EC200U GSM module instead of EC25 with omega2+
@Lazar-Demin Thanks. I am trying to interface. I will keep you posted.
-
is it possible to use EC200U GSM module instead of EC25 with omega2+
Hi,
Does any one have a idea that the existing GSM, GPS software works with EC200U-CN. Currently, I don't have any issue with EC25. Due to unavailability of stock and cost, I am planning to use EC200 as a replacement.
Thanks in advance.Regards,
Naveen -
RE: GPRS connection - how to set up ppp connection on openWRT linux
@Nagarjuna-Reddy said in GPRS connection - how to set up ppp connection on openWRT linux:
chat comgt
Hi @Nagarjuna-Reddy
does this works with any SIMCOM module? I am trying to interface A7672 with Omega.
This PPP link works on USB or UART?
It would be great if you could write bit around the hardware.Thanks in advance.
Regards,
Naveen -
RE: Omega2s+ and EG25-G Interface error: ifconfig: SIOCGIFFLAGS: No such device error
@Lazar-Demin Thanks. we had issue with USB detection.
-
Omega2s+ and EG25-G Interface error: ifconfig: SIOCGIFFLAGS: No such device error
Hi,
I am trying to run EG25-G on custom board. Used below method to install the LTE driver.
- opkg install - Success
- opkg install omega2-lte-base - Success
- o2lte apn "www"
Setting APN to www
Done- o2lte data enable
Enabling LTE data connection
ifconfig: SIOCGIFFLAGS: No such device
/etc/rc.common: line 1: can't create /sys/class/net/wwan0/qmi/raw_ip: nonexistent directory
DoneDoes anyone have any idea about what is going wrong. Do I need to add anything in the network config /etc/config/network
Naveen
-
RE: Omega 2S, Error 12: Out of memory after installing SD card
@Lazar-Demin My bad. Yes it is RAM. How can I add Swap file with SD card, I can see the document is for USB drive. is there any tutorial for it, My understanding was, we add SD card automatically swap file have been added. I see no Swap file has been created.