The new Console release is here!

Lazar Demin

@Mark-Larson ok, we'll make sure to add that to the docs!

Also, we've just gotten our second correct codename guess! Only one more prize left!

Lazar Demin

We've fixed the issues with the GPIO app, upgrade to the latest firmware to grab the fixes!

Theodore Borromeo

@Lazar-Demin Ok, so now the initial setting works. But try to transition the pin back to 'input' after setting it to 'output' + 'a value'. Will the old hack still work in that case? I tried this on GPIO1.

Theodore Borromeo

@Lazar-Demin yeah, old hack doesn't seem to work

Lazar Demin

@Theodore-Borromeo it should work with no hacks required now! going from 'output' -> 'input' should just require changing the Direction in the drop-down menu and a press of the Sync button.
Let me know how it goes.

Theodore Borromeo

@Lazar-Demin I haven't tested it, but quick question:
Does setting a pin as input and as a 1 cause a pull-up circuit? If not, then perhaps the software should just disallow level setting when the pin is an input

Lazar Demin

@Theodore-Borromeo the Value drop-down menu isn't clickable when the Direction is set to Input. Clicking Sync will take a reading of the pin's current value and then display it.