MODBUS RTU
-
I did not realize Modbus is RS485.
Does this mean that I already built a triple Modbus dock by accident by doing this?
(3 RS485 interfaces, Ethernet, 5..39V to 3.3V regulator, fitting into nice small Hammond 1591XXA case - designed to control Swiss Railway split-flap display modules)
-
Yes if it's rs485 you just need to configurate the protocol, but remember most ModBus devices runs on 24V
-
What omega did you use? If you implement this on Omega2 I’d be interested as everything I tried to get rs485/232 TTL support for the omega2 I ran out of space on the device...
I was however able to install python3-light, python3-pip and MinimalModbus on my omega2+ no problem. Omega2 doesn’t even have enough space to install both python3-light and python3-pip
-
Is this RS485 adapter also 9bit aka multidrop capable ?
-
@cory-callcott hi, if you read the documentation you'll find that there is a procedure to do overlay and use either a sd card or usb storage device. i use a 16GB flash drive and that gives me plenty of space.
-
@Douglas-Kryder Thanks i'll look into it, I did read something about it but thought it was just for the 2+ model as it came with a sd card slot.
-
@Gerhard-Bertelsmann Just using a cheap usb to rs232/ttl adaptor I think I got like 10 or so off ebay for like $10~15 a year or so ago. So far seems to work fine on omega2+.
-
@cory-callcott
AFAIK none of the cheap USB2Serial devices is able to transfer 9bit. You can emulate it with mark/space parity but it takes a lot of time switching between the modes and hurts badly the effective transfer rate.
-
Hello, I would be very interested in your omega to Modbus RTU as I would like to control an inverter which has Modbus from a PLC that works through the Omega onion.
-
This post is deleted!