[OMEGA2S] TX1 and RX1 seem to be switched

[Heptner Heptner]

I'm trying to use RX1 and TX1 for UART communication and I can't get it to work.

RX2/TX2 works fine.

Investigating this issue I found that in contrast to the documentation, Pin45 seems to be sending instead of Pin46.

Before I start tearing up a clean and completely soldered selfmade breakout-board in order to change these lines, I would like to confirm that this is an issue and can not be resolved by setting a different bit somewhere.

[Lazar Demin]

@Heptner-Heptner Yeah, this was a case of a mislabelled pinout. We've corrected it: https://github.com/OnionIoT/Onion-Media/blob/master/Pinouts/Omega2S.png